Nissan Off Road & 4x4 Forum

Vehicle Specific => D21 Pathfinder / Hardbody / Terrano => Topic started by: Justinhb on April 21, 2014, 08:10:52 PM



Title: SYE
Post by: Justinhb on April 21, 2014, 08:10:52 PM
If calmini doesnt offer a SYE then where does still ? I didnt see one here.. anyone point me in the right direction


Title: Re: SYE
Post by: conor1123 on April 21, 2014, 09:08:00 PM
For which vehicle?

Here's the pathfinder one. http://www.calmini.com/detail.php?b=1&m=3&t=3&p=1161&n=

All of the SYEs seem to have the same part number on Calmini so i'm guessing they are all the same.


Title: Re:
Post by: SteeevO on April 23, 2014, 05:05:31 AM
I don't believe Calmini makes these anymore. As far as I know they still advertise them however they don't have them.

I can make one for you but I need slip yokes as cores. If you can send one in I can make a sye with both 1310 and 1350 bolt patterns in it. Feel free to give me a call to order.

Sent from my Desire HD using Tapatalk


Title: Re: SYE
Post by: conor1123 on April 23, 2014, 09:46:43 AM
Ah, my bad! I keep forgetting that Calmini isn't removing this stuff off their site!


Title: Re: SYE
Post by: Justinhb on September 23, 2014, 03:56:13 AM
if I send you a yoke from a 2 peice driveshaft will that work..? from my stock driveshaft...what ya think the turn around is on that and cost? message me if ya like  or hell even text me 7176239234 ive finally got the hardbody out again... so its time to continue the build I had started.. also interested
 a a driveshaft


Title: Re: SYE
Post by: SteeevO on September 23, 2014, 09:32:59 PM
Justin,
If you need a 1310 CV Rear Driveshaft, it will be about $374.95. if you don't need a cv then the price will drop pretty good.
The SYE Yoke/Flange with 1310&1350 patterns in it is $149.95
Shipping will vary depending on where we are sending it to.

Feel free to give me a call during the week as well 909-547-4651


Title: Re: SYE
Post by: ehtrain on October 01, 2014, 06:44:03 PM
is it possible to just by the slip joint anywhere? You could make what ever you wanted with that possibly?


Title: Re: SYE
Post by: Justinhb on February 10, 2015, 07:51:59 PM
so whats everyone do when it get to the point a SYE is needed? is one offered here? any pics?  does any other spline count drive shaft fit that they make a SYE for.. whats the splince count on a jeep tcase?


Title: Re: SYE
Post by: SteeevO on February 11, 2015, 05:58:21 PM
you can either retube the driveshaft to accomodate the length or
if you have a spare OEM slip yoke I can make a SYE