Nissan Off Road & 4x4 Forum

Vehicle Specific => D21 Pathfinder / Hardbody / Terrano => Topic started by: 69cory420 on April 22, 2013, 12:49:17 PM



Title: Nissan SAS
Post by: 69cory420 on April 22, 2013, 12:49:17 PM
I'm currently in the process of doing a SAS with some full widths from a 79 Ford f250, gonna leaf it 6" up, and run 37-12.5-16.5 just looking for some pointers, on ease of installation, any thoughts??


Title: Re: Nissan SAS
Post by: theking on April 22, 2013, 08:58:22 PM
I believe Steevo has a front output flange in the works for the tx10 that will fit a CV driveshaft.  You will want to cut and rotate the knuckles so the pinion angle is setup for a CV and about 5 degrees caster.  edit: (wait, i forgot,  for leafs you will need to use shims under the leaf pad since the pad is cast into the pumpkin.  Just one of the many things that sucks about leaf over).   Also he may have a trans crossmember from his kit that will work for your application.  
      


Title: Re: Nissan SAS
Post by: SteeevO on April 22, 2013, 09:25:28 PM
I believe Steevo has a front output flange in the works for the tx10 that will fit a CV driveshaft.  

Yes, these will be out very soon.
I won't have them advertised for a few more months but if you need one sooner, give me a ring.

909-547-4651